|
|
|||||||
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specify the key within the work area | Zoom | SAP ABAP | 1 | 03-19-2011 04:53 PM |
| Trapping key presses in the cl_salv_table | Rampa | SAP ABAP | 2 | 03-10-2011 12:48 AM |
| Is the license key connected to the hardware? | Rima | SAP BASIS | 4 | 06-29-2010 04:09 PM |
| Add attributes for InfoObject? | papa | SAP BW/BI | 0 | 01-05-2010 02:07 PM |
| Lost key figure data when active ods | sapen | SAP BW/BI | 1 | 04-10-2009 11:28 PM |
| Aprenda SAP! |
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
08-25-2011, 12:41 AM
|
|||
|
|||
InfoObject Key Issue
Hello experts,
I need to create infoobject as Warrenty Type as Master data infoobject and Component key as Component code. I was loading data from flat file, data sequence as Warranty Type and Component code. some reason in communication and transferrules showing first Component code then Warrenty Type when i load the test file warrenty type values are loading component infoobjects and component values are going into warrenty type infoobject. I was loading only infoobject not PSA. This problem only happening when i define component key. How to change the key sequence in communication structue or Transfer rule in any other Thanks in advance, ERP 
|
| Sponsors |
|
#2
08-25-2011, 12:43 AM
|
|||
|
|||
|
Re: InfoObject Key Issue
Hi ERP,
Check the flat file and the data source. Your flat file should have same sequence defined in data source. Your sequence might be wrong. Just check it. Regards, Portal
|
| Entre a los Links relacionados |
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
